Differences

This shows you the differences between two versions of the page.

--- sonobus [2021/03/31 08:27] – [Multi-Channel Setup Illustrated - AUM] monitoring espiegel123
+++ sonobus [2021/03/31 08:29] – [Multi-Channel Setup Illustrated - AUM] espiegel123
@@ Line 48: / Line 48: @@
 {{:sonobus_input_mixer_setup_4.jpg?600|}}
-Also set the monitoring output routing for each of the input groups, in this case you will want to use the same Aux # output as you used for the input so that AUM will have access to it. The button on the right side of the input groups lets you select the monitoring output. (TODO: the screenshots show that 1-2 are selected for monitor routing but they should be updated).
 After you have added all your buses, you will have something like this:
 {{:sonobus_input_mixer_setup_5.png?600|}}
+MONITORING SETUP
-By default, each input is monitored by the main Sonobus instance (the sender) rather than on its own bus. It is usually convenient to have each input monitored on it original bus. The pictures below demonstrate how to set this up.
+By default, each input is monitored by the main Sonobus instance (the sender) rather than on its own bus. It is usually convenient to have each input monitored on its original bus. The pictures below demonstrate how to set this up.
 {{:sonobus_monitor_setup_1.jpg?600|}}