Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
sonobus [2021/03/31 04:02] – add pictures espiegel123 | sonobus [2021/03/31 08:29] – [Multi-Channel Setup Illustrated - AUM] espiegel123 | ||
---|---|---|---|
Line 11: | Line 11: | ||
**Private Group**. The simplest way is to use a Private Group. For the group name, enter the group name that all the Sonobus instances will connect to. For example, " | **Private Group**. The simplest way is to use a Private Group. For the group name, enter the group name that all the Sonobus instances will connect to. For example, " | ||
- | **Connect to Raw Address**. Sonobus will let you connect directly to another Sonobus instance directly even if wifi is turned off. For people that need to have wifi off, this method is convenient because you can enter use the address 127.0.0.1 which means "send to the device I am on" which works even if wifi is off. When using Connect to Raw Address, you enter the address of a different | + | **Connect to Raw Address**. Sonobus will let you connect directly to another Sonobus instance directly even if wifi is turned off. For people that need to have wifi off, this method is convenient because you can enter use the address 127.0.0.1 which means "send to the device I am on" which works even if wifi is off. When you tap on " |
===== Multi-Channel Sending ===== | ===== Multi-Channel Sending ===== | ||
Line 27: | Line 26: | ||
=== Adding the Sonobus Instances === | === Adding the Sonobus Instances === | ||
- | {{: | + | {{: |
- | {{: | + | {{: |
After you have added all your ' | After you have added all your ' | ||
+ | |||
{{: | {{: | ||
Line 37: | Line 37: | ||
=== Setting up the Input Mixer in the Master Instance === | === Setting up the Input Mixer in the Master Instance === | ||
+ | In the master Sonobus instance that actually sends the audio out, you need to bring in each of the sources that you want to send out. In the Sonobus receivers, the receiver will be able to grab whichever of the sources are needed. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | After you have added all your buses, you will have something like this: | ||
+ | {{: | ||
+ | MONITORING SETUP | ||
+ | By default, each input is monitored by the main Sonobus instance (the sender) rather than on its own bus. It is usually convenient to have each input monitored on its original bus. The pictures below demonstrate how to set this up. | ||
- | **STUB -- MORE PICTURES NEEDED HERE** | + | {{: |
+ | {{: | ||
{{tag> | {{tag> |