Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
loopy_pro:midi_troubleshooting [2024/04/01 14:18] – add section about looking through bindings espiegel123 | loopy_pro:midi_troubleshooting [2024/04/13 04:31] (current) – espiegel123 | ||
---|---|---|---|
Line 26: | Line 26: | ||
* Use a standalone MIDI Monitor to see if your iPad or iPhone is seeing MIDI from the controller. | * Use a standalone MIDI Monitor to see if your iPad or iPhone is seeing MIDI from the controller. | ||
* If MIDI is seen, make a note of what messages (and on what channels), your controller is sending | * If MIDI is seen, make a note of what messages (and on what channels), your controller is sending | ||
- | * MIDI Learn triggering a clip in Loopy Pro's default document. | + | * MIDI Learn triggering a clip in a new project made from Loopy Pro's default document. |
* If strange things happen when you send a MIDI message you mapped, turn off the **Feedback Enabled** for the controller in Loopy Pro's Control Settings | * If strange things happen when you send a MIDI message you mapped, turn off the **Feedback Enabled** for the controller in Loopy Pro's Control Settings | ||
==== Use A MIDI Monitor to See if MIDI Is Received ==== | ==== Use A MIDI Monitor to See if MIDI Is Received ==== | ||
+ | of | ||
Before troubleshooting: | Before troubleshooting: | ||
* Fully shut down your device using "Slide to power off" rather than putting it to sleep at waking it up. | * Fully shut down your device using "Slide to power off" rather than putting it to sleep at waking it up. | ||
Line 58: | Line 58: | ||
* Launch Loopy Pro | * Launch Loopy Pro | ||
* Create a new document using Loopy Pro's default document | * Create a new document using Loopy Pro's default document | ||
+ | * Choose Clip Settings from the main menu | ||
+ | * Scroll to the bottom of the settings panel and choose **Restore Defaults** | ||
+ | * In Control Settings, turn off any Global Profiles that are enabled. This step is to ensure there is not some conflict with MIDI bindings that might be interfering. | ||
* Turn on MIDI Learn mode | * Turn on MIDI Learn mode | ||
* Tap on the upper-left clip | * Tap on the upper-left clip |