Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| loopy_pro:footswitches [2024/04/09 04:48] – tweak language espiegel123 | loopy_pro:footswitches [2024/04/20 00:12] (current) – Add fcb info espiegel123 | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| **Short Tread/Long Tread Mode**. The Short Tread/Long Tread mode lets you set up a different messages to be sent for short and long press. This can be very convenient to send different message on short and long press, but it is important to understand that the response time is not as fast with this mode as with Manufacturer Control or the options that send an ON message immediately on press. In Short Tread/Long Tread mode, the short press message is sent on **release** of the short press. This adds about 120ms of delay to the sending of the press compared to the modes that send one message on press and another on release. The short/long tread mode has the advantage of slightly less delay for hold message than when mapping the same pedal to short and long press in Loopy Pro. When using this mode, you will want to have the short press send both an on and an off message so that Loopy does not interpret the short press as a hold. | **Short Tread/Long Tread Mode**. The Short Tread/Long Tread mode lets you set up a different messages to be sent for short and long press. This can be very convenient to send different message on short and long press, but it is important to understand that the response time is not as fast with this mode as with Manufacturer Control or the options that send an ON message immediately on press. In Short Tread/Long Tread mode, the short press message is sent on **release** of the short press. This adds about 120ms of delay to the sending of the press compared to the modes that send one message on press and another on release. The short/long tread mode has the advantage of slightly less delay for hold message than when mapping the same pedal to short and long press in Loopy Pro. When using this mode, you will want to have the short press send both an on and an off message so that Loopy does not interpret the short press as a hold. | ||
| + | |||
| + | ==== FCB1010 ==== | ||
| + | For best results, use it in notes mode. In that mode a note on message is sent on press and a note off on release. This allows midi learn of tap, double-tap and hold. The other modes send an event only on press. | ||
| + | |||
| + | People report that controller feedback (found in Loopy Pro’s Control Settings panel) should be off for this device. | ||
| + | |||
| + | There is an app that simplifies this device’s setup. | ||
| {{tag> | {{tag> | ||
espiegel123