groove_rider_gr-16

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
groove_rider_gr-16 [2019/05/22 03:21] – [Videos and Tutorials] espiegel123groove_rider_gr-16 [2019/11/26 04:14] – [Tips & Tricks] slicing tips espiegel123
Line 66: Line 66:
   - Under Pattern, set the pattern you want to chain to under Chain To   - Under Pattern, set the pattern you want to chain to under Chain To
   - Optionally set the number of times you want the pattern to loop before chaining with "Chain Repeat"   - Optionally set the number of times you want the pattern to loop before chaining with "Chain Repeat"
 +
 +** Wavetable Tips **
 +In the Files app, place Serum-compatible wavetables directly into Groove Rider's Wave folder. Do not put them in subfoders.
 +
 +**Slicing Tips.** Here are [[https://forum.audiob.us/discussion/comment/716941/#Comment_716941| some slicing tips from @rs2000]]:
 +
 +  * Hit TRIGGER, tap on a part (pad) you want to put the sliced loop on.
 +  * Hit Oscillator > WAVE, in the left LCD column scroll down to "User" and choose either a factory loop or "Load from AudioShare" on the bottom.
 +  * Tap SLICE twice to see the whole breakbeat waveform.
 +  * Hit the different pads and you'll see that each pad is set to play one of sixteen pre-set slices.
 +
 +If they're good, you're done already.
 +
 +If you want to move them, my personal fastest way is:
 +
 +  * Enable SHIFT lock by tap-dragging the SHIFT button downwards or upwards (will flash yellow)
 +  * hit each pad, roughly change "SLICE START" (and END if you like)
 +  * On the waveform display, tap and drag your finger down to the max (max. zoom level)
 +  * Hit each pad again and fine-tune if necessary. The display will automatically move to the point you're adjusting.
 +
 +Another tip for creating a step sequence with slices:
 +
 +  * On a sliced part (TRIGGER > hit the pad to select it), hit SEQ > EDIT, then SLICE.
 +  * Now you can tap on the step to edit with your left finger and hit the pad you want there with your right finger.
 +  * Being able to "scroll" through the slice sequence and change each step fast and easily is one of the many hidden gems in Groove Rider.
 ===== Audiobus Forum Threads of Note ===== ===== Audiobus Forum Threads of Note =====
 There are quite a few GR-16 discussions on the [[http://forum.audiob.us|Audiobus Forum]] here are a few in which there is some gold buried: There are quite a few GR-16 discussions on the [[http://forum.audiob.us|Audiobus Forum]] here are a few in which there is some gold buried:
  • groove_rider_gr-16.txt
  • Last modified: 2020/02/07 07:24
  • by _ki