Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
beepstreet_drambo [2021/07/13 17:43] – Mentioned Gate+Velocity sequencer rs2000 | beepstreet_drambo [2023/03/02 19:56] – skrat | ||
---|---|---|---|
Line 32: | Line 32: | ||
Polymetric sequences with different sequencer lengths on different tracks can be achieved by adding a " | Polymetric sequences with different sequencer lengths on different tracks can be achieved by adding a " | ||
- | In addition to the main sequencer tracks, there are additional | + | In addition to the main sequencer tracks, there are sequencer modules that work like classic modular CV/Gate sequencers. The most important one would likely be the Misc => Gate+Velocity Sequencer module which can also used for controlling oscillator pitch. |
==== Routing ==== | ==== Routing ==== | ||
Line 380: | Line 380: | ||
* Holding Mute and tapping on track will solo it, mute will remain blinking while such solo is enabled | * Holding Mute and tapping on track will solo it, mute will remain blinking while such solo is enabled | ||
* Dragging unit slightly to the side reveals (+) button to add unit in between, when you release the finger while seeing the (+) button, the Add unit popover will show up and the unit will be added in the respective place. | * Dragging unit slightly to the side reveals (+) button to add unit in between, when you release the finger while seeing the (+) button, the Add unit popover will show up and the unit will be added in the respective place. | ||
+ | |||
+ | === Stems recording === | ||
+ | Stems recording allows to save audio files into Drambo/ | ||
+ | |||
+ | For starting stems recording, the tape in top bar must be on (red) and playback must be running. The moment the recording is started depends on: | ||
+ | 1. If the recording was turned on while playback was stopped, it starts immediately after playback is started | ||
+ | 2. If the recording was turned on while playback was running, it start immediately after recording tape icon is pressed. | ||
+ | Note you can find out if the stems recording is running by " | ||
+ | |||
+ | To stop the recording, you there are also two options: | ||
+ | 1. Stop playback, which will immediately cut the recording the moment you hit the stop button. | ||
+ | 2. Turn off tape icon in top bar, then the recording will be stopped after the next bar, allowing you to record files that are stopped precisely on the bar end - perfect for using the stems as loops. | ||
+ | After a recording is saved, you see an information text with where the file(s) were saved, it should be Drambo / Samples / Recordings. The files are store in a directory named in format " | ||
+ | |||
==== modular Resources | ==== modular Resources |