Differences

This shows you the differences between two versions of the page.

--- beepstreet_drambo [2020/12/17 15:57] – [Signals] rs2000
+++ beepstreet_drambo [2020/12/17 17:03] – [Routing] rs2000
@@ Line 23: / Line 23: @@
 ==== Workflow and sequencer ====
+Drambo is a virtual modular synthesis and sequencing studio that consists of modular synthesis tracks, each with a corresponding sequencer track. The synthesis tracks can be chosen by hitting the corresponding drum pads.
+An audio mixer channel representation of all tracks that also allows for scrolling through tracks can be shown by hitting the upper right "burger menu" symbol, while a grid representation of all sequencer tracks can be shown by hitting the upper right dot grid symbol. As Drambo supports both landscape and portrait orientations of your iDevice, more sequencer or modular synthesis tracks can be seen by turning the device into portrait mode.
+It can be a good idea to place tracks next to each other that may require simultaneous tweaking, especially when using AUv3 plugins that rely on visuals.
 Drambo's sequencer is built around a pattern concept. Each pattern has a certain number of steps and repeats and unless the "Loop" symbol on the transport bar is enabled, all patterns will play in a linear sequence. After the last pattern has finished playing, Drambo will continue playing the first pattern again.
 The sequencer has a modular concept, much like the synthesis modules but with features specific to sequencing. Sequencer step modules are called "Step Components" and they can be shown by hitting the STEP button on the right. Apart from the most common "Note" component, many other step components are available that perform certain actions or define conditions under which the following step component is executed. This is one way to play, for example, a sequenced note only every 4th pattern repeat or randomly at this position.
 Polymetric sequences with different sequencer lengths on different tracks can be achieved by adding a "Jump" step component on any sequencer step. It allows for jumping to any other step in the sequence as soon as the playhead in this sequence reaches that step.
+==== Routing ====
+Drambo allows you to connect modules without wires. Tapping on a signal port which is not yet connected will show all ports that can it can be connected to, which are all modules that are located before the module you're about to connect. When designing modular creations, keep this limitation in mind, as it may in some cases (instant Feedback) require a few duplicate modules to achieve the same effect as in classic modular systems.
+Connections are indicated in two ways: The color of a signal port is the same as the module it receives from, and when you tap on a signal port, both the port and the connected port will flash in orange color.
+Double-tapping on a signal port will open a popup menu to disconnect that port.
+Routing is not limited to a track. You can also route signals between tracks, including track mixer modules in the "Main" channel. When routing MIDI signals, be aware that routing MIDI to a track will make the MIDI signal available to track modules, not to the sequencer.
 ==== Signals ====